Top Pyramyd Air Deals for September 2025

Brought to you by Fox 2 Industries, these high visibility fiber optic sights replace the hard to see factory sights on the First Strike FSC paintball launcher. Retains stock mounting screws. Please Note: you will need to install the colored fiber on the front post after tightening set screw. The filament is installed over the screw and then bulbed with a lighter. Rear sight comes with Green rods installed. 1 red and 1 green rod will be supplied for the front sight. Made in Maine, USA

Universal PUNCH BUTTON for Umarex T4E Series Launchers

Co2 punch button cover for the GEN 2 Umarex T4E series paintball launchers. Makes CO2 removal a breeze!  Made in Maine, USA.  Listing is for cover only. (No piercing button, no launcher)

Co2 punch button cover for the GEN 2 Umarex T4E series paintball launchers. Makes CO2 removal a breeze!  Made in Maine, USA.  Listing is for cover only. (No piercing button, no launcher)

Co2 punch button cover for the GEN 2 Umarex T4E series paintball launchers. Makes CO2 removal a breeze!  Made in Maine, USA.  Listing is for cover only. (No piercing button, no launcher)

Co2 punch button cover for the GEN 2 Umarex T4E series paintball launchers. Makes CO2 removal a breeze!  Made in Maine, USA.  Listing is for cover only. (No piercing button, no launcher)

This cover allows you to loosen and tighten the CO2 puncher screw without tools for quick insertion of the CO2 cartridge. To install place punch button cover over the splines of the punch button and tighten. Once tightened you may need to remove the punch button cover and place it closer to the straight position. It may be necessary to loosen the puncher screw until the cover is straight. Once aligned you are able to tighten and loosen the puncher screw without tools.

This cover allows you to loosen and tighten the CO2 puncher screw without tools for quick insertion of the CO2 cartridge. To install place punch button cover over the splines of the punch button and tighten. Once tightened you may need to remove the punch button cover and place it closer to the straight position. It may be necessary to loosen the puncher screw until the cover is straight. Once aligned you are able to tighten and loosen the puncher screw without tools

Umarex Glock 17 Gen5 T4E Paintball Pistol